1988 Corvette voltage leak

by Roland
(Winnipeg Mb. Canada)

My 1988 Corvette has a battery leak with ignition off. I put a test light between positive battery post and posive cable and there is voltage. I pulled out the fuses one by one and it didnt make any difference. My battery and starter are new but I have to have at least 14 volt on battery for sarter to engage I there a voltage leake on Positive wire going to the sarter?

Comments for 1988 Corvette voltage leak

Average Rating starstarstarstarstar

Click here to add your own comments

Jan 09, 2012
Voltage leak
by: Anonymous

Just had this done today my seat switches 1 of them was stuck in the down position

Aug 06, 2011
battery drain
by: Dallas Dave

Had the same thing last month - the 2 door switches that show the doors as shut were not contacting and the security system thought the doors were open - thus running the security system the entire time - would drain the whole system in 2 days.

Jul 30, 2011
by: Corvette web central

Did you try using an Ammeter to determine the rate? Use that tool and disconnect your starter or fuses and anything else that is on the 12v constant power side. Then after you locate the circuit at fault look for a stuck switch bad relay or short to ground or chassis.

Click here to add your own comments

Join in and write your own page! It's easy to do. How? Simply click here to return to C4 Corvette Ask!.

Search Our Site for Your Corvette Information Needs!

Save With Our Factory Direct Supporting Vendors

Eckler's Corvette